In a laboratory study, 85% of standing-posture measurements showed no link with how the foot moved in walking. Studies since 1996 point the same way. That is the gap this article is about.
Here is what each common method captures, what the research says about predicting movement from posture, and what a walking assessment adds.
What do today's methods capture?
Most orthotic work starts from one of three records.
| Method | What it records | Typical position |
|---|---|---|
| 3D foot scanner | The surface shape of the foot | Standing, seated or lying, held still |
| Cast or foam impression | A physical mold of the foot's shape | Held still, with little or no weight on the foot |
| Standing pressure mat | How pressure is distributed at the mat's surface | Standing still |
Each one answers a real question. A scan or a cast gives the shape a device has to match. A standing pressure record shows how the patient distributes weight at rest. Some pressure systems also record walking, barefoot across a plate or inside the shoe, and that answers a different question again.
The limit is the same for every static record: it describes one held position. It does not show how long the foot stays on the ground, how it rolls from heel to toe, which way it points during the step, or whether left and right behave alike.
Can you predict movement from posture?
Only in part, and study after study has said so.
Clinicians have long used static posture to infer how a foot will behave in gait. That assumption has been tested since the 1990s:
| Study | Participants | What standing measures showed |
|---|---|---|
| McPoil and Cornwall, 1996 | 27 healthy adults | One of 17 measurements predicted rearfoot pronation, and it explained 17% of it |
| Nielsen et al., 2010 | 280 adults | The Foot Posture Index predicted 13% of the variation in navicular drop during walking, and 45% of navicular height |
| Paterson et al., 2015 | 31 young men | 85% of posture items showed no correlation with foot motion, whichever of three methods was used |
| Jarvis et al., 2017 | 100 adults | Static assessment findings and foot motion in gait were not correlated |
Sources: McPoil and Cornwall, Journal of Orthopaedic & Sports Physical Therapy, Nielsen et al., Gait & Posture, Paterson et al., Journal of Orthopaedic & Sports Physical Therapy, Jarvis et al., Journal of Foot and Ankle Research.
Posture is not irrelevant: flatter feet tend to move more, and a systematic review found some evidence for that. Buldt et al., Gait & Posture, 2013. The link is partial, and the authors of the 2010 study recommended dynamic measures for clinical foot assessment.
A sharper picture of the still foot is not a measurement of the moving one.
What does a walking assessment add?
A dynamic assessment records the patient in motion. Depending on the system, it can describe:
- Timing: how long each foot spends on the ground and in the air.
- Left and right: whether the two sides move alike.
- Foot progression angle: which way the foot points as the patient walks.
- Foot roll and push-off: how the foot moves from landing to propulsion.
These are movement findings. They are not treatment targets, and no single number prescribes a device. They give you a second record to set beside the shape: this is the foot, and this is what it does over a series of steps.
How do the two fit together in practice?
- Start from the question. A device that must match a contour needs the shape. A complaint that appears during walking deserves a look at walking.
- Keep the records apart. Shape, standing pressure and movement are three different things. Name each one for what it is in the note.
- Record the conditions. Footwear, a walking aid and an existing device all change what a walking assessment shows.
- Repeat after fitting. A scan cannot tell you how the patient walks with the new orthotic. A second walking assessment, under the same conditions, shows what changed.
For the follow-up itself, use the orthotic follow-up checklist. For the wider comparison, see static versus dynamic foot assessment.
Where does Baliston Health fit?
We add the movement. Sensor insoles equipped with AI Mov-Scan capture the patient's walk in suitable shoes. AI Mov-Scan captures. The platform analyzes and generates the Full Clinical Report. Balia, the platform's AI assistant, explains. The practitioner decides.
You review left/right symmetry, foot progression angle, foot roll and push-off beside the shape record you already take. After fitting, you repeat the assessment and compare. The prescription stays yours.
See orthotics informed by how they walk, explore Baliston Health for podiatry, or book a demo.



